Technical requirements for nursing pad sheet

(1) product model / specification and division description

1.1 the medical care mat is divided into type I non-woven fabric, type II non-woven fabric with plastic film, type III toilet paper with plastic film, type IV non-woven fabric and plastic film with toilet paper sewn or pressed and thickened water absorbing type.

1.2 medical care pads are divided into: type A: Maternity pad; Type B: medium single; Type C: bed sheet; Type D: hole towel; Type E: quilt cover; Type F: pillow case.

Specification and model of medical care pad unit: cm

(2) performance index

2.1 see Table 1 for the specifications and models of medical care pads.

2.2 appearance

The medical care pad shall be flat, free of obvious defects, stains, damages, abnormal smell and foreign matters.

2.3 sewing or heat sealing

The medical nursing mat shall be sewn firmly, and shall not be off thread or needle skipping. The sewing thread density shall not be less than 8 stitches / 3cm, and the sewing margin shall

Not less than 0.3cm. Such as heat sealing shall be firm without cracking.

2.4 tightness

Add a medical care pad for the membrane, and the membrane shall not be permeable.

2.5 the medical care pad shall meet the health standards, the total number of bacterial colonies ≤ 200 CFU / g, the total number of fungal colonies ≤ 100 CFU / g,

Coliform bacteria and pathogenic pyogenic bacteria shall not be detected.

3 test method

3.1 basic dimensions

The measurement with ordinary tape or steel ruler shall comply with the provisions of 2.1.

3.2 appearance

Hand feeling and visual sensory inspection shall meet the requirements of 2.2.

3.3 sewing

The measurement with steel ruler shall meet the requirements of 2.3.

3.4 pour water on the pressed suture and the film coated part. After 1min, there is no water mark on the reverse side. Put the sealed small package into the water containing height

The bottom of the 0.5m container shall be slowly moved up to the water surface for a moment. Whether there is bubble shall comply with the provisions of 2.4.

3.5 health requirements

It shall be inspected according to the hygienic standard of disposable sanitary articles, and the results shall meet the provisions of Article 2.5.